Choose a part according to the PlayStation model
Individual PlayStation models and their hardware revisions may use different spare parts. Therefore, knowing only the console generation is not enough when choosing. The exact model designation and compatibility of the original component are also important.
Choose a spare part according to the fault
Problems with the display, power supply, cooling or controls can have various causes. See the most common fault symptoms and the components that may be related to them.
Distinguish between the console and the controller
Console parts concern power supply, display, cooling or the drive. Controller parts address motion sensing, buttons, charging, the battery, flex cables, membranes and covers. DualSense for PlayStation 5 and DualShock 4 use different designs and designations, so they cannot be interchanged based solely on a similar name.
How to choose the right spare part
Before ordering, compare the console generation, the Slim or Pro variant, the controller designation and the hardware revision. For power supplies, check the designation, such as ADP or APS; for fans, check the number of blades or the intended version; and for controllers, check the board or model designation. If the designation does not match, the appearance of the part alone is not sufficient proof of compatibility.
Frequently Asked Questions (FAQ)
Not automatically. DualSense and DualShock 4 use different controller designs, so you must choose a part intended for the specific model.
A hardware revision indicates a specific version of the device or board that may determine the shape, connector and electrical compatibility of the part.
The fan may be suspect in the event of unusual noise or insufficient cooling, but before replacing it, dust, the power supply and other possible causes must be ruled out.
Not automatically. Individual console versions use different power supplies. Before ordering, compare the exact designation of the original power supply and its compatibility.
Yes. The cause may be the HDMI cable, connector, control chip or another component of the display circuit. The cause of the fault must be identified before replacement.
